Flash Story

Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might locate that your garage door opener has actually been providing you troubles, so you need to repair it. You can fix it by replacing a circuit card, a photo-eye sensor, the main drive gear, or the set-limit buttons. You can also examine if the security sensing units are functioning properly.

Replacing a circuit card

Replacing a motherboard for your garage door opener needs a few steps and also devices. Initially, you need to shut off the breaker and detach any type of wires. Next, open up the circuit card cover. This will help you to identify the problem and identify if you require a brand-new board. Next, get rid of the old board as well as its wire connectors.

You can then proceed to change the circuit card. The substitute process is easy as well as takes about 10 mins. A brand-new motherboard will cost concerning $80. To protect your new circuit board from power rises, you can acquire a rise protector.

Replacing a photo-eye sensing unit

Changing a photo-eye sensor can be a rather easy job. Initially, get rid of the sensor from the door and ensure it is located appropriately. If the sensor is angled in any way, it may not be getting the right signal, which could be triggering the strobe lights. If you observe that the photo-eyes run out positioning, you might need to have actually a technician come as well as fix the issue.

The photo-eye sensor contains two items that install on the outside of the door tracks as well as toward the flooring. The image eyes will have a small LED light and also need to be strong in color. If the light is blinking, its likely the photo-eye is malfunctioning and also will certainly need to be changed.

Changing a main drive equipment

To change a garage door opener main drive gear, begin by eliminating the cap from the chain wheel. Next off, get rid of both screws holding the drive equipment to the gear setting up. Now, you can unfasten the 3 stress pins. Squeeze them from both sides and after that eliminate them. Then, disconnect the three cords from the garage door opener motor. These wires need to be white, red, and blue.

Once you have actually removed the old equipment, install a new one. Be sure to oil it well. Place the new gear right into the shaft, making certain to align the mounting openings. Make sure the equipment as well as gear setting up are located properly to guarantee smooth operation. Next, use a hammer and a nail to drive a pin into the brand-new gear.

Readjusting the set-limit switches

The initial thing you should do if your garage door is not working properly is to inspect the set-limit buttons. You may need to adjust them to make sure that the door shuts earlier or quits prior to it reaches the floor. You can inspect this by looking at your garage doors guidebook or online.

To adjust the set-limit switches, youll need a screwdriver or outlet. Change the knob clockwise or counterclockwise up until the door moves up as well as stops, or minimizes its distance. To check for appropriate travel distance, determine the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top