Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may find that your garage door opener has actually been providing you troubles, so you require to fix it. You can repair it by changing a circuit board, a photo-eye sensor, the main drive equipment, or the set-limit buttons. You can likewise check if the safety sensors are working appropriately.

Replacing a circuit board

Changing a circuit card for your garage door opener needs a couple of steps and devices. First, you require to switch off the breaker and also detach any cables. Next, open up the circuit board cover. This will certainly help you to identify the trouble and determine if you require a new board. Next off, eliminate the old board and its cord ports.

You can then continue to replace the circuit board. The substitute process is very easy as well as takes about 10 minutes. A new circuit card will set you back regarding $80. To secure your new circuit card from power surges, you can purchase a surge guard.

Replacing a photo-eye sensor

Replacing a photo-eye sensing unit can be a fairly simple task. Initially, eliminate the sensor from the door and also make sure it is located properly. If the sensor is angled at all, it might not be receiving the correct signal, which might be causing the blinking lights. If you notice that the photo-eyes run out placement, you may need to have actually a professional come and fix the problem.

The photo-eye sensing unit includes 2 items that install outside of the door tracks and towards the floor. The picture eyes will have a small LED light and also should be strong in color. If the light is blinking, its most likely the photo-eye is faulty as well as will need to be changed.

Replacing a major drive gear

To change a garage door opener major drive gear, beginning by eliminating the cap from the chain pulley-block. Next off, remove both screws holding the drive gear to the sprocket setting up. Currently, you can unfasten the three stress pins. Squeeze them from both sides and after that remove them. Then, separate the 3 cords from the garage door opener electric motor. These cords need to be white, red, as well as blue.

Once you have gotten rid of the old equipment, set up a new one. Make sure to oil it well. Insert the brand-new equipment into the shaft, making certain to align the placing openings. Make sure the equipment and gear assembly are located properly to ensure smooth operation. Next, use a hammer and a nail to drive a pin right into the brand-new gear.

Readjusting the set-limit buttons

The initial point you should do if your garage door is not functioning properly is to examine the set-limit buttons. You might need to change them so that the door shuts earlier or stops prior to it gets to the floor. You can inspect this by considering your garage doors guidebook or online.

To change the set-limit buttons, youll require a screwdriver or socket. Adjust the knob clockwise or counterclockwise until the door goes up and stops, or minimizes its distance. To check for correct travel distance, measure the gap from all-time low of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top