Veteran Garage Door Repair | Keller TX | 817-769-8488

Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may find that your garage door opener has been providing you problems, so you need to fix it. You can repair it by changing a motherboard, a photo-eye sensor, the primary drive gear, or the set-limit switches. You can also check if the safety and security sensors are functioning effectively.

Replacing a motherboard

Replacing a circuit card for your garage door opener needs a couple of actions and also devices. Initially, you require to turn off the circuit breaker as well as disconnect any cables. Next, open the circuit board cover. This will aid you to identify the issue as well as identify if you need a brand-new board. Next off, get rid of the old board and its cord adapters.

You can then proceed to replace the circuit card. The replacement process is easy and takes around 10 mins. A brand-new circuit card will cost about $80. To secure your brand-new circuit card from power rises, you can buy a rise guard.

Changing a photo-eye sensor

Replacing a photo-eye sensor can be a fairly basic job. Initially, get rid of the sensor from the door as well as ensure it is located appropriately. If the sensor is angled whatsoever, it may not be getting the proper signal, which could be triggering the strobe lights. If you see that the photo-eyes run out alignment, you may need to have a specialist come as well as fix the issue.

The photo-eye sensing unit contains two pieces that install outside of the door tracks and also toward the flooring. The picture eyes will have a small LED light and should be solid in shade. If the light is blinking, its most likely the photo-eye is faulty and will require to be changed.

Changing a main drive equipment

To change a garage door opener primary drive gear, beginning by removing the cap from the chain pulley-block. Next, get rid of the two screws holding the drive gear to the gear setting up. Now, you can unfasten the three tension pins. Press them from both sides and after that eliminate them. After that, separate the 3 cables from the garage door opener electric motor. These wires must be white, red, and blue.

Once you have removed the old gear, set up a brand-new one. Make sure to oil it well. Put the new gear right into the shaft, ensuring to line up the installing holes. Ensure the equipment and also gear setting up are positioned properly to ensure smooth operation. Next, utilize a hammer as well as a nail to drive a pin into the new gear.

Changing the set-limit buttons

The very first point you must do if your garage door is not functioning properly is to examine the set-limit switches. You might need to adjust them to ensure that the door shuts earlier or stops before it gets to the floor. You can check this by taking a look at your garage doors handbook or online.

To adjust the set-limit buttons, youll need a screwdriver or socket. Adjust the knob clockwise or counterclockwise till the door moves up as well as stops, or minimizes its distance. To check for appropriate traveling distance, gauge the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488
Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top